How to Install Epoxy Anchor in Concrete

How to Install Epoxy Anchor in ConcretennProper installation determines 80% of anchor performance. Follow these manufacturer-recommended steps.nn## Step-by-Stepnn1. Drill hole: rebar diameter + 4-6mm, depth minimum 10x rebar diameter.n2. Clean: blow with compressed air, wire brush, blow again. Repeat 2x minimum.n3. Inject: nozzle to bottom, fill from bottom up, keep nozzle submerged.n4. Insert rebar: slow rotating motion. Adhesive should squeeze out the top.n5. Do not disturb: 24 hours at 25C for full load.nn## Temperature EffectsnnAt 10C: 72 hours cure. At 35C: 12 hours cure. Below 5C: use low-temp formula.nn## FAQnnCan I use in overhead holes? Yes. Our thixotropic formula stays in overhead holes.nnView epoxy anchors | Contact us